Search results for "Partial molar property"
showing 10 items of 14 documents
Thermodynamic Behavior of Non-Ionic Tri-block Copolymers in Water at Three Temperatures
2006
Apparent molar volumes (V Φ) of aqueous solutions of some copolymers, based on ethylene oxide (EO) and propylene oxide (PO) units, were determined as functions of concentration at three temperatures. Viscosity measurements were also carried out on some of these systems. The effects studied include how the molecular architecture and the molecular weight affect the aggregation of the copolymer, keeping constant the EO/PO ratio. Modeling of the volumetric data yielded the partial molar volume of the copolymer in the standard (V°) and the aggregated (V M) states, as well as the equilibrium constant for micellization and the aggregation number. Analysis of the viscosity data supported the insigh…
Mass action model for solute distribution between water and micelles. Partial molar volumes of butanol and pentanol in dodecyl surfactant solutions
1986
The densities of 1-butanol and 1-pentanol were measured in aqueous solutions of dodecyltrimethylammonium bromide and dodecyldimethylamine oxide and the partial molar volumes at infinite dilution of the alcohols in aqueous surfactants solutions were obtained. The observed trends of this quantity as a function of the surfactant concentration were rationalized using a mass-action model for the alcohol distribution between the aqueous and the micellar phase. At the same time, the model was revised to account for the alcohol effect on the surfactant micellization equilibrium. The partial molar volume of alcohols in the aqueous and in the micellar phases and the ratios between the binding constan…
Thermodynamic properties of alcohols in a micellar phase. Binding constants and partial molar volumes of pentanol in sodium dodecylsulfate micelles a…
1984
Densities of the ternary system water-sodium dodecylsulfate (NaDS)-pentanol and of the binary systems butanol-octane and pentanol-octane were measured at 15, 25, and 35 °C. The apparent molar volume of pentanol in the ternary system was analyzed using a mass-action model for the alcohol distribution in micellar solutions. The partial molar volume of alcohol bound to the micelles and the ratio between the binding constant and the aggregation number of the surfactant are calculated. The partial molar volume binding constant, is discussed in terms of solubilization sites of the alcohol in the micelles whereas the binding constant is compared with that derived from the Nernstian partition const…
Effect of Large Changes in Temperature and Pressure on the Thermodynamic Properties of Micellization and on the Distribution Constant of a Polar Solu…
1996
Density measurements of pentanol (PentOH)−dodecyltrimethylammonium bromide (DTAB)−water mixtures as functions of both alcohol and surfactant (mS) concentrations were carried out at 0.1 MPa from 45 to 75 °C and at 19 MPa from 25 to 130 °C. The standard (infinite dilution) partial molar volumes and expansibilities of DTAB in water and the corresponding properties in the micellar phase were calculated from the experimental data. As far as PentOH in DTAB micellar solutions is concerned, with the exception of the standard partial molar volume (V°R) data at 130 °C and 19 MPa, all the V°R vs mS trends are monotonic curves with mS. The data of V°R as a function of mS were treated by means of an equ…
Aqueous nonionic copolymer-functionalized laponite clay. A thermodynamic and spectrophotometric study to characterize its behavior toward an organic …
2006
The affinity of functionalized Laponite clay toward an organic material in the aqueous phase was explored. Functionalization was performed by using triblock copolymers based on ethylene oxide (EO) and propylene oxide (PO) units that are EO(11)PO(16)EO(11) (L35) and PO(8)EO(23)PO(8) (10R5). Phenol (PhOH) was chosen as organic compound, which represents a contaminant prototype. To this purpose, densities and enthalpies of mixing as well as PhOH UV-absorption spectra were determined. The enthalpy and the spectrophotometry revealed PhOH-Laponite interactions whereas the volume did not. It emerged that the area occupied by PhOH on the Laponite surface is equal to that computed from the partial m…
Thermodynamics of Solubilization of Pentanol in Sodium Dodecyl Sulfate-Dodecyldimethylamine Oxide Mixed Micelles
1994
Abstract Heat capacity and density measurements of pentanol (PeOH)-sodium dodecyl sulfate (NaDS)-dodecyldimethylamine oxide-water mixtures were carried out at 0.03 m PeOH as a function of the total surfactants concentration (mc) at different ratios (XNaDS). From experimental data, the apparent molar volumes (VΦ,R) and heat capacities (CΦ,R) of PeOH in the surfactants mixture solutions were calculated. As a general feature, at a given mixture composition, VΦ,R increases monotonically with mt as observed in pure surfactants. In the cases of XNaDS = 0.1 and 0.3, VΦ,R drops at about 0.1 and 0.15 mt respectively. The decreasing CΦ,R VS mt curve shows peculiarities which were ascribed to the pres…
Enthalpy of Solution of Nonionic Solutes in Organized Systems
1989
The standard enthalpies of solution of alcohols in micellar solutions of dodecyltrimethylammonium bromide were obtained by direct measurements and by enthalpies of mixing. The observed trends were analyzed with a previously reported model. From the resulting equations, the distribution constant, standard enthalpy of transfer from aqueous to the micellar phase and the standard enthalpy of solution in micellar phase can be calculated at the same time using a linear least-squares analysis. The model seems to hold well also in the case of short chain surfactants and microheterogeneities in spite of the fact that the micellization equilibrium is treated as a pseudo-phase transition.
Volumetric properties of binary mixtures of ionic liquid 1-butyl-3-methylimidazolium octylsulfate with water or propanol in the temperature range of …
2006
Abstract Densities of 1-butyl-3-methylimidazolium octylsulfate ([bmim][OcOSO3]) solutions in water and 1-propanol have been measured with an oscillating-tube densimeter at temperatures from 278.15 K to 328.15 K. From these densities, apparent molar volumes Vϕ of [bmim][OcOSO3] in both solvents have been calculated, and its dependence on the molality has been treated with the Redlich and Meyer equation. Debye–Huckel limiting slopes for 1-propanol at working temperatures have been calculated, and apparent molar volumes of [bmim][OcOSO3] at infinite dilution V ϕ ∘ in both solvents have been evaluated. The partial molar volume at infinite dilution of [bmim][OcOSO3] in water is higher than in 1-…
Demixing of Mixed Micelles. Thermodynamics of Sodium Perfluorooctanoate−Sodium Dodecanoate Mixtures in Water
1997
Conductivity, density, heat capacity, enthalpy of dilution, and osmotic coefficient measurements of water−sodium perfluorooctanoate (NaPFO)−sodium dodecanoate systems were carried out as functions of the surfactants' total molality (mt) at different mole fractions (XNaPFO). From conductivity data, the critical micelle concentration (cmc) and the degree of ionization (β) of the micelles were derived. The cmc's of the micelles are higher than those of the pure surfactants while β depends linearly on XNaPFO. At a given mole fraction, the apparent molar volume (VΦ) and heat capacity (CΦ) of the mixture increases and decreases monotonically with mt, respectively. From data in the premicellar reg…
Thermodynamics of Micellization of Sodium Alkyl Sulfates in Water at High Temperature and Pressure
2001
Apparent molar volumes VΦ,S were determined for sodium octyl, decyl, and dodecyl sulfates in water at 2 and 19 MPa from 25 to 130 °C. The shapes of VΦ,S vs the surfactant concentration curves depend on the surfactant alkyl chain, temperature and pressure. The standard partial molar volumes were calculated from data in the premicellar region whereas the partial molar volumes of the surfactant in the micellar phase were obtained from data in the postmicellar region. The partial molar expansibility and compressibility were evaluated from the dependence of the partial molar volume on temperature and pressure, respectively. Attention was focused to the expansibility and its pressure coefficient …